@joseph said in maxcul measurementOffset without effect:
Whats my mistake ?
Can you please post the device config you’re using? Did you use the “transfer config” button to transfer the offset from the settings to the device itself?
The following info may also of be of interest:
“If the internal temperature sensor is not well calibrated, it may produce a systematic error. Using measurementOffset, this error can be compensated. The reading temperature is equal to the measured temperature at sensor + measurementOffset. Usually, the internally measured temperature is a bit higher than the overall room temperature (due to closeness to the heater), so one uses a small negative offset. Must be between -3.5 and 3.5 degree celsius.”
https://github.com/fbeek/pimatic-maxcul/issues/20
"It always takes longer than you expect, even when you take into account Hofstadter's Law.", Hofstadter's Law