In the Script Line 30 must removed or uncomment.
Because Pimatic must have the Output 1 or 0.
Then it works in PiMatic too.
-
Fritzbox WLAN Script SomeOneAtHome
-
You are right! Line is deleted.
-
Have anyone else the Problem that the FritzBox 7490 don’t check directly that a Device is disconnect?
My FritzBox write that no WLAN Connection avaible to the Device but the Output from the Script is 1.
After 30 Minuten changed the Output to 0.I think it’s a Problem from the FritzBox
-
Did you reboot you box in the meanwhile?
-
Yes, same Problem after Reboot.
-
With power plug removed? Normally full reset power plug remove. Not via Web interface.
-
Yes, i habe removed Power Plug.
-
Strange! I have no idea why this happens.
-
Yes, i have this Problem only with the FritzBox 7490.
FritzBox 7360 and FritzBox 7330 works fine.I think i reset the FritzBox and import my config after the Reset.
-
Before this try to delete this device over Web access from your box if it’s only one and reconnect with new IP.
-
I have delete the device from my box but nothing changed.!
I have make some Screeshots.
The Output from The Script:
Fritz Box Info of the Device
-
The Output come only from the FritzBox 7490.
I have execute the Script with every IP alone. And only the FritzBox 7490 show this situation. -
I think i gotcha… This is not a fault of your box. I think your phone will be connected to another fritzbox?
I request all box and if any box is true then output will be true. For me sounds that your phone is connected to another box. You can check this if you use only ip of 7490.
Another thing, where are this 1 0 is coming? Are you type this line into console? Than this will be wrong. Its not needed. Maybe this was a fault to…
-
WLAN on the Phone is deactivated. And the Output 1 come only by the Fritz Box 7490. I have try the Script by use one IP. The Error ist only by the 7490.
Is 1 0 not needed? I have copy the Line from a Post from this Forum. I will remove the 1 0 from my Line. But the Script works fine every time.
-
No sir, 1 0 is not needed. It will be ignore by my script.
Did you read out via console command or via pimatic to confirm 30 minutes network stay?
How many times are you check devices with pimatic. Did you check other devices in the meanwhile? -
I read out via console command and Pimatic. Is would check only one device. The interval is 12000ms.
The network stay is differently. Some times 5 minutes up to 3 hours.
-
12000ms??? That is toooo short… Set to 60000 each minute is really enough. Otherwise you will float your box with to much request.
-
Ok, i will changs this too.
But i think that is not the Problem. -
Using this since today. Great stuff works for me…
Would be nice to have this out of the box from pimatic a mobilePresenceSensorFritz or something like this.
-
I’m not familiar with coffee script and I don’t have time to learn another script language. So if there is a developer, it would be nice to create a plugin for that thing.
But I’m lucky that my script works for other people and would proud to share it.