Big problem with alarm1/alarm2
Hello community,
I have two types of fire detectors. The FA20RF and the FA21RF.
I configured both in pimatic alarm1/alarm2 and I’m able to trigger them. The problem is, that signal lasts only for round about five seconds.
It doesn’t matter whether I configure a time interval via rule or not. After five seconds the signal stops.
when contact-terrasse is closed and if alarm-status is on then turn alarm-master on for 120 seconds
@SaxnPaule Can you please post the device configuration you have setup for the smoke detectors?
"It always takes longer than you expect, even when you take into account Hofstadter's Law.", Hofstadter's Law
{
"protocols": [
{
"name": "alarm1",
"options": {
"id": 174xxxx
}
}
],
"id": "alarm-master",
"name": "Alarm Master",
"class": "HomeduinoRFSwitch"
}
Atm I solved the problem by using a workaround, but that’s really no good solution.
I have a rule that triggers the alarm every three seconds.
If alarm-state is turned on and every 3 seconds then turn alarm-master on
Alarm-master has the ‘force send’ attribute set.
A second rule turns the alarm off after a defined duration.
If alarm-state is turned on then turn alarm-state off after $alarm-duration seconds